Foreskin Restoration!

A group for circumcised guys that are trying to restore their foreskins. The aim of the grup is to for a discussion group and to assist other men who share the same interest

I have pulled and tugged for like the last 5 years, used every kind of device I can find, and some I made myself. to get the job done.
I'm pretty much satisfied with my progress but still always wanting it stretched more.
I do have coverage and it stays covered all the time unless it hard.
I do have sensitivity back and really do love that.
My hopes were to get a snout on the end. but my cock just is just to short for one.
I still use the retainer from the DTR and added weights on it I wear it around the house from time to time.
Now I am into stretching my balls sack. The feeling of them slapping my thighs is great.
so that is the journey I am on now.

This topic was edited
RE:My Journey

I also want to stretch my balls out so they hang really low but I read it can affect fertility and I want to have kids later on in life.

This post was edited
RE:My Journey

I've been restoring for years on and off some devices and a lot of tugging , in the morning and throughout most of the day my little penis looks uncut or as I call it a acorn but i'm still not happy because when semi or hard i'm just another cut guy. I saw on another site where a guy had surgery and imo someone did a great job but i'm still bothered why was I cut in the first place. I am lucky as a lot of guys complain of being cut tight apparently the doctor who cut me cut me very loose and if I wasn't so lazy I could have been restored long ago. as for my balls I stretch -tug them too I love low hangers

This post was edited
RE:My Journey

Just be sure you do your research. I am way pass worrying about that part. Like they say if it hurts your probably doing it wrong!

This post was edited
RE:My Journey

ever use steel ballweight shackles/cuffs? I've enjoyed the progress so far. I'll have no problem if the nuts slap against my knees someday. halfway there with heavy steel bolted on!

This post was edited